My Kenmore Washer Won T Drain. It's also common for a small sock or other article of clothing to get caught in the drain pump or in the drain hose. Ideally, the drain hose should be standing 30 inches (76.2 centimeters) from the base level.
In these situations, the water needs to be manually drained before the washer can be serviced. If the valve itself is. Check both for an obstruction before replacing the pump.
To Determine If The Lid Switch Assembly Is Defective, Use A Multimeter To Test Each Of The Lid Switches For Continuity.
Why won’t my kenmore washer drain or spin? When washers don’t spin, it’s usually because of a problem with the rotor — the part with blades that slings water from the tub. Every kenmore model has the same type of water draining system that removes water from the washer tub at various points during the wash cycle.
The Drain Pump Is Either Not Getting Power Or Defective, Preventing It From Draining The Water.if You Suspect A Bad Drain Pump, Check Its Continuity With.
Try dividing the laundry into two parts and starting the wash with. The good news with your kenmore series 70 washer is that there are only three or four areas that could be causing your kenmore washer not to be draining properly. If the lid switch assembly fails, the washer will not drain.
There Are Multiple Likely Causes For This Issue—These Include:
If your kenmore 110 series washing machine is not draining after a wash cycle, see the kenmore 110 series washing machine won’t drain problem page for possible causes and solutions. Plug in the washer and turn the water back on. The first thing you need to check is the height of your washer drain.
Remove The Drain Hose And Clean It With A Mild Detergent.
First, check the drain hose to determine if it is kinked, twisted, or bent. If kenmore washer won’t drain, check: A simple fix would be to pull the hose up a few inches.
If Your Washer Won’t Drain Or Spin, The Water Level Control May Be Faulty.
If your washing machine isn’t working properly and you don’t hear a humming sound when it’s on, the control board might be broken. Most of the time, the drain hose slowly gets pushed too deep into the valve due to daily use. Before you take apart your kenmore washer, check the door first.
Location:
Share :
Post a Comment
for "My Kenmore Washer Won T Drain"
Post a Comment for "My Kenmore Washer Won T Drain"